Disasters usually happen in homes due to electrical mistakes hence maintenance is recommended. Today, many homes are more concerned with electrical codes compared to the past.
Therefore, it is important to regularly check the electrical wiring in your home with the help of the top electrical contracting companies. Electrical rewiring is very important in our homes because it can result in a huge disaster if ignored.
Many areas would not allow unlicensed homeowners to perform wiring in their house because they can pose a risk of electrical fire due to faulty wiring. However, you can do the wiring with the help of a licensed electrician and contact the top electrical contracting companies. Below are some tips you need to consider when rewiring your house to ensure safety and security. They include:
Electrical inventory: The inventory describes the amount of energy your house needs and the way to rewire your house.
Permits and coding: Electrical permits and coding are usually checked by specialists. Therefore, you should consider consulting an electrical inspector to check your house despite its age.
Present-day appliances: It is very important to read all the requirements and conditions of the new devices before installing them. This is because most of the old homes may lack the capacity for the new electrical appliances.
Doing your homework and research: You should understand the number of electrical devices you house can manage. In other words, you need to know about the necessary and unnecessary electrical appliances or devices to be used in your home. Therefore, you need to consult a certified electrician so that you can have a chat about plans of rewiring so that you can conclude the right system for your home.
Active infrastructure: A certified electrician would best recognize and differentiate active spots from passive spots. This is in regards to punching holes or drilling through the walls that are considered to be safe for installing the live wiring.
Designing a wiring diagram: Designing a wiring diagram helps in showing you the position or location of the breaker box and also the path followed by each wire.
Installing conduits: This involves running the longer wires first. This helps to avoid wastage of conduits in the walls. You should begin by wiring from the upstairs coming down to the basement. This will minimize the process of pulling the wires up. You should also consider leaving the one-foot extra wire on the edges so that it can be easy to move things around the house when required.
Knowing the outlet count: You should be able to determine the number of switches and outlets that can run on a single circuit. It is advisable to use six outlets for every 110-voltage circuit in a living room and 2 outlets per circuit in the kitchen. This is because appliances in the kitchen use more wattage.
Drilling wire holes: When drilling, you need to be very careful to prevent committing any mistake. When drilling through the walls or floors, you need to understand the obstacles present on the other side. This is because you may drill through water pipes, electrical wires, or ductwork. When you ensure that everything is good to go, start drilling holes that are one inch deep to provide room for your wire travel.
Setting a breaker: You need to set a breaker for future reference. This can be done in a utility room or in the basement.
Pulling wires to the exits: You should make sure that you place the wire beside the breaker box and then pull it to the nearest outlet or switch for every circuit. You can also decide to run the wire straight into the box. Wires that may stick out of the box may be cut or drywalled since they are unnecessary.
You should always use wire strippers to get rid of the outer coating of the wires and read the instructions carefully at every outlet, switch, box, or fixture before conducting the attachment.
Installing the circuits: Make sure that you install and fix individual circuits for every wiring set. It is very important to note that the circuits should always match with the wire’s amperage and also the projected purpose and function of the outlet. A mismatch would lead to further damages which would be dangerous if not checked.
In Conclusion
Before you decide to rewire your house, consider following the above steps carefully to avoid any kind of electrical problems. From time to time, electrical systems usually display signs when there is a potential problem with the wiring. These problems can be a result of bad quality electrical wiring.
You should, therefore, consider using good quality wires that are durable and that can protect your home from any kind of electrical issues. Remember to consult a certified electrician in case you do not know how to fix or install wires to ensure everything is safe.